![]() Multiple Fans w/One Switch: This is a common question and while this has. There's a length of two core that carries the live from the top switch down to the bottom one and back to where it is connected to the red.įor the switching to be on the live side, the black incoming will be connected to the white of the three core - which again should be sleeved (or wrapped in black tape). Again, we are unable to give specific wiring advice ourselves due to liability issues. The white in the two core feed in the ceiling again goes to the white of the fan. When regular two core is used for the run to the switch, the white should be sleeved black to indicate that it is also hot.įor this, the white in the three core is used to take the feed down to the two switches, and the red and black carry the two switched feeds back, these would then be connected to the live feeds into the fan (they're usually black and blue, and should have tags indicating which is which). With a single load, typically a further two core would be used to carry the live out to the switch and back, by wire-nutting the two together (or using a spare terminal on the light fixture, and thw switched return and the white neutral would then go to the light. Helping You to Wire It Right See the Electrical Wiring Video 2 Below: How to Wire a 2 Stack Switch for a Ceiling Fan and Light Wiring Two Toggle Type Stack. ![]() The two core plus ground is the incoming feed to the light fixture. The question is what wires from the ceiling box are hooked to what wires on the ceiling fan? The new fan has four wires and I know that the blue is the light: Make sure the plastic switch boxes and lightbox are all properly affixed to the studs or joist and that Romex cable is fed through them. The bottom switch has a set of wires coming in from the top that are: White - Hooked to White on top AND to top of switch.White - Hooked to White on bottom AND to top of switch. ![]() The top has a set of wires coming into the switch box on the top and bottom: ![]() The top switch controls the fan and the bottom switch controls the lights. There are two separate light switches (they are not side-by-side as you'd expect, but are top and bottom and are about six inches or so apart. I also tested them flipping the switches. So I have two sets of wires coming into the ceiling box. I am sure that electrical standards vary place to place I am in the United States specifically Michigan. I know I screwed up, but now it is a learning opportunity. I messed up and forgot to take a picture of the wiring. ![]() So I am replacing my bedroom ceiling fan. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |